Why is damaged a tanker the reasons why a tanker is damaged always are three: the deterioration of the float, the deterioration of the valve inlet or the mechanism that controls the water discharge. We normally realize that something is wrong in our system by the permanent noise or water loss that produces. The float and valve controlled inlet. The fault may be in that float do not sufficient pressure to close or that the valve does not work. Whether what is defective is the flush valve you will also notice a continuous noise of water. Materials needed to fix a cistern are: an adjustable wrench, pliers, teflon tape and valve or replacement float. How to fix a tank, if you have to replace the float: in the event the problem is in the float, must be replaced by a new one. To do this: cut the water with the stopcock, remove the float, replace it with one of the same model and finally conveniently adjust the float by bending the Rod.
How to fix a tank, if you need to change the valve if the problem is with the valve, must follow these steps: shut off water with shut-off valve, disassemble the intake system, which is typically located next to the own cistern. To remove it is necessary to loosen the nut and remove another inner nut which is smaller diameter. Then remove the mechanism and replace it with the new. Then put teflon tape on the place where the nut holding the valve to the pipe is inserted. And finally tighten all the nuts of the mechanism, to get it securely. For assistance, try visiting Ebay. How to fix a tank, if you need to change the mechanism of shock if what is damaged is the download mechanism, will have to find out if it is the rubber that closes the step which is broken or if it is a rupture of any part of the unloader: will first cut the water. If you are replacing the rubber inside, will have to completely empty the tank.
Then unscrew the unloader and can easily replace the rubber piece. If you notice that what is damaged is any part of the mechanism must be replaced it entirely, simply desaflojando that unite the unloader with cistern and external nuts. Finally, put the new mechanism. Following these simple steps you will learn how to fix a tank yourself and without the help of professionals, thereby saving that this will entail you. Original author and source of the article.